ULTRA TREK SUIT LINER
This is the most advanced Waterproof/Windproof/Breathable Liner made today. Gore-Tex and other breathable membranes have a 20% or more plastic "Polyurethane" coating on the face fabric. In warmer weather this plastic coating does not allow the material to breathe properly. Our New Aero-Tex Liner has no Polyurethane coating on either the face fabric or inner mesh lining.
A common question is: "What if it's hot and raining and I want to stay dry"? The liner can be left on even in warmer weather. You will still be more comfortable than any other Waterproof/Breathable/Windproof suit in the world. Without any Polyurethane coating on the outer suit material, the Aero-Tex can perform better. When its over 85F and raining, most riders prefer not wearing the liners in the rain.
Some riders comment that they don't like the outer shell getting wet when the waterproof liner is on the inside. The uncoated outer suit material completely dries in less than five minutes when riding. With the majority of other suits the outter Polyurethane coated shell gets wet before hitting the waterproof membrane. The Polyurethane traps the water, sometimes taking hours to dry.
Some riders comment that they don't want to have to remove the suit to put on the liner. I don't know of any riders that put on a rain suit before it starts to rain. Trying to put a rain suit over a one piece suit that is wet is by far more difficult than simply removing the suit in seconds. Stepping into the one piece liner, not necessary to remove boots, pants or shirt underneath, and then putting on the Ultra Trek Suit over the liner.
Another reason to wear the liner underneath is that the waterproof membrane breathes much better when it is closer to the skin. Our long distant riders love wearing the Aero-Tex Liners in a sleeping bag at night or when walking around the campground during cold nights.
Features
- 100% Waterproof/Windproof/Breathable guaranteed for the life of the garment.
- A three way flap seal covering the main entry zipper and left leg zipper, making it impossible for water to enter even at speeds over 100mph
- High quality fleece lined neck
- Liner can be worn by itself when riding or off the bike.
- Liner zips into the suit and can be left in for 7 or more months of the year in most parts of the country. Snap loops connect sleeves and cuffs of the suit.
- Custom alteration available.
Sizing
For correct pant sizing you need to provide the following measurements:
1. Height
2. Weight
3. Inseam
4. Actual Waist
5. Crotch to center of knee. (For proper knee armor location.)
Follow these instructions to measure for the correct placement of knee/shin armor and inseam:
1. Sit on your motorcycle wearing regular pants and boots/shoes usually used when riding.
2. Assume your usual “riding position” with your lower body.
3. Put your thumbs and middle fingers together forming a large circle (thumb to thumb, middle finger to middle finger).
4. Place this circle, made with your four fingers together, over the knee to cover the knee properly for riding.
5. Mark the top of the circle on the pant leg with tape.
6. Straighten the knee. From the top tape line go down the leg 5 inches and put another tape line. You have just marked where the knee armor will go.
7. STAY IN A SEATED POSITION and straighten the leg out to the side. Lay the ruler between the two tape lines perpendicular to the pant inseam. Extend the ruler straight over to the inseam of the pant and mark the spot with tape where the inseam and ruler intersect.
8. Measure from the crotch straight down the inseam to the inseam-ruler intersection mark.
9. Measure from the crotch of the pant where it is sewn together down to the end of the cuff. Add more if the jeans are too short to use while riding.
Please call or email your measurements to ensure proper fit. For riders that require custom sizing please call 800-777-6499 or email motoportusa@earthlink.net.
Warranty
• Customer Satisfaction 100% Guaranteed on all standard sized, standard color pants.
• To support the claims made by Motoport about Kevlar, and to confirm the protective/long lasting qualities of clothing made from Kevlar, this garment has a 7-year warranty.
• IF YOU EVER CRASH, AT ANY SPEED, IN A MOTOPORT KEVLAR GARMENT (SUIT, JACKET, PANT, OR SHIRT) AND MOTOPORT CAN'T REPAIR IT, MOTOPORT WILL REPLACE THE GARMENT FOR FREE.
More Information
• Machine washable armor and all.
• Repairs or alterations can be made.
• Motoport may have your size in stock but depending on the time of year it usually averages four weeks to make the pant. Please call for more accurate ship dates.
• Motoport makes this pant for you to the exact size. ?Alterations and repairs can be made.
• Designed to be worn over jeans or shorts. Motoport's Air Mesh Kevlar Pant is the only Air Mesh Pant that is safe to wear shorts underneath in hot weather. (No Polyurethane coating to melt into legs!)