Product name: Jolly PATROL BOOT
Article number: 7027/GA
Full-grain cowhide leather, waterproofed, black, 1.8 – 2.0 mm thick. Top and collar lining
Full-grain soft aniline leather, waterproofed, black, 1.0 – 1.1 mm thick
Seam sealed 4 ply laminate (GORE-TEX® LIGHT ROCK), bootie construction:
Layer 1 – Abrasion-proof lining 70% PA / 30% PES
Layer 2 – Functional nonwoven 100% PES
Layer 3 – Waterproof and water vapour permeable ePTFE membrane
Layer 4 – Backing fabric knit 100% PA
First quality velcro material
1.3 mm resinated synthetic bonded fabric, thermally mouldable.
1.8 mm resinated synthetic bonded fabric, thermally mouldable.
Heat moulded material with shock-absorbing properties.
8 mm wide, with plastic teeth.
Polyester thread, 20/3 title, water-repellent treated, black.
Non rusting steel with 4 mm diameter hole
Round black lace, water-repellent treated
Rubber sole, antistatic, oil and petrol resistant, with shock-absorbent heel. Resistant to contact heat (tested at 300°C) and slip resistant SRC.
abt. 2010 g (size 42)
abt. 42 cm (sole included) (size 42)
EN ISO 20347:2012 O2 HI HRO CI WR FO AN – SRC Category II P.P.E.
36 – 49
* This product price DOES NOT reflect delivery costs, these costs are calculated and charged at the time of shipment. Please read our Ordering Process for more information.
Motoport Sizing Guides
Please call or email your measurements to ensure proper fit. For riders that require custom sizing please call 1-800-777-6499 or email email@example.com.
Please call for more accurate ship dates. 1-800-777-6499
To ensure proper sizing Motoport needs: Height / Weight / Sleeve (from center at base of neck around outside of arms to bend in wrist). To give us the most accurate sleeve measurement, follow the Dress Shirt Sleeve instructions below. Actual Chest / Actual Waist. (No jacket or pant sizes.)Do not inhale when measuring chest. Waist should be measured where you tighten the belt. All measurements taken in a relaxed position. Tape measure should also be comfortable, not tight or loose.NOTE:If ordering Aero-Tex liner we need a neck circumferance measurement at collar height or 2″ from the base of your neck.
Follow these instructions to measure for correct sleeve length
Measuring a motorcycle jacket alone is not good. Please help to confirm the proper sleeve length by measuring a Dress Shirt Sleeve length as shown below. Also make sure to mention when providing this measurement, that this is a dress shirt sleeve length not a jacket sleeve length measurement, measured as shown in Sizing Detail.
Note: Your dress shirt sleeve measured as shown above should be approximately 2″ shorter than the jacket sleeve length measured.
After we receive the above measurements, we will advise if any other measurements are necessary.